TY-BNC
Category:SPD for coaxial
BNC Type Coaxial Signal Lightning Protector
Tel:+86-577-62605321
Email:andy.xu@tycotiu.com
PDF Download
Features:
Comply with IEC61643-21 standard
Characteristic impedance：50Ω
Protection level：IP20
Insertion loss：≤0.3dB
Connectiion：BNC
Parameters:
Model
TY-BNC
Test standards
IEC 61643-21
Nominal voltage
Un
5V
Max. continuous operating voltage
Uc
6VDC / 4V AC
Nominal current
IL
0.5A
Voltage protection level [line-shield]
Up
≤30V
Operating temperature range
Tu
-40℃-80℃
Connection input / output
BNC
Enclosure material
aluminium alloy
Degree of protection
IP20
C2 Nominal discharge current (8/20μs)[line-shield]
In
5kA
C2 Nominal discharge current (8/20μs)[shield-PG]
In
10kA
Voltage protection level [shield-PG]
Up
≤500V
Response time [line-shield]
tA
≤1ns
Response time [shield-PG]
tA
≤100ns
Bandwidth
10 Mbps
Insertion loss
≤0.3dB
Impedience
50Ω
Application:
It is suitable for lightning protection of various radio frequency signal receiving and transmitting systems.
It is mainly used for surge protection of cable TV transmission system, CCTV video surveillance system equipment (such as hard disk recorder, matrix, optical terminal, camera) of coaxial cable transmission line
Prevent the surge invading the equipment along the feeder and causing damage
Installation and Maintenance:
Install in series in front of the protected equipment (or system)，install as close to the protected equipment (or system) as possible.
The input end of the lightning protection device is connected with the signal line, and the output end is connected with the protected equipment, which can not be connected in reverse.
The product does not need special maintenance, Install as close to the device end as possible; When the work system failure, can be removed the lightning protection device, if system restored to the state before the use of normal, it should be replaced lightning protection device.
